NAME
mos —
Moschip MCS7730/MCS7830/MCS7832 USB
Ethernet driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your kernel configuration file:
device uhci
device ohci
device ehci
device usb
device miibus
device uether
device mosAlternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
if_mos_load="YES"
DESCRIPTION
Themos driver provides support for USB Ethernet
adapters based on the Moschip MCS7730/MCS7830/MCS7832 chipset.
The adapters that contain the Moschip MCS7730/MCS7830/MCS7832 chipset will operate at 100Base-TX and full-duplex.
The Moschip contains a 10/100 Ethernet MAC with MII interface and is designed to work with both Ethernet and HomePNA transceivers. Although designed to interface with 100Mbps peripherals, this only works with USB 2.0. The existing USB 1.0 standard specifies a maximum transfer speed of 12Mbps. USB 1.0 Users should therefore not expect to actually achieve 100Mbps speeds with these devices.
The Moschip supports a 64-bit multicast hash table, single perfect filter entry for the station address and promiscuous mode. Packets are received and transmitted over separate USB bulk transfer endpoints.
For more information on configuring this device, see ifconfig(8).
HARDWARE
Adapters supported by the mos driver
include:
- Sitecom LN030
SEE ALSO
altq(4), arp(4), ifmedia(4), miibus(4), netintro(4), ng_ether(4), ifconfig(8)
ADMtek AN986 data sheet, http://www.moschip.com/data/products/MCS7830/Data%20Sheet_7830.pdf.
HISTORY
The mos device driver first appeared in
FreeBSD 8.2.
AUTHORS
The mos driver was written by
Rick van der Zwet
<info@rickvanderzwet.nl>.