NAME
virtio_scsi —
VirtIO SCSI driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your kernel configuration file:
device virtio_scsiAlternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
virtio_scsi_load="YES"
DESCRIPTION
The virtio_scsi device driver provides
support for VirtIO SCSI devices.
LOADER TUNABLES
Tunables can be set at the loader(8) prompt before booting the kernel or stored in loader.conf(5).
- hw.vtscsi.bus_reset_disable
- In the initial QEMU release with VirtIO SCSI support, in-flight operations were not aborted when stopping the device, rendering bus reset ineffective. This tunable disables attempts to issue reset bus commands. The default value is 1.
DEBUGGING
To enable debugging prints from the
virtio_scsi driver, set the
hw.vtscsi.X.debug_level
variable, where X is the adapter number, either in loader.conf(5) or via sysctl(8). The following bits have the described effects:
- 0x01
- Enable informational prints.
- 0x02
- Enable prints for driver errors.
- 0x04
- Enable tracing prints.
SEE ALSO
HISTORY
The virtio_scsi driver was written by
Bryan Venteicher
<bryanv@FreeBSD.org>.
It first appeared in FreeBSD 10.0.