targ(4) - Manual pages

SYNOPSIS

To compile this driver into the kernel, place the following line in your kernel configuration file:

device targ

The targ driver provides an interface for usermode programs to emulate SCSI target devices. A sample program that emulates a disk drive (similar to da(4)) can be found in /usr/share/examples/scsi_target.

The targ driver supplies the control device /dev/targ. After opening the device, the file descriptor must be bound to a specific bus/target/LUN and enabled to process CCBs using the TARGIOCENABLE ioctl. The process then uses write(2) to send CCBs to the SIM and poll(2) or kqueue(2) to see if responses are ready. Pointers to completed CCBs are returned via read(2). Any data transfers requested by the user CCBs are done via zero-copy IO.

IOCTLS

The following ioctl(2) calls are defined in the header file <cam/scsi/scsi_targetio.h>.

TARGIOCENABLE

(struct ioc_enable_lun) Enable target mode on the LUN specified by the following structure:

struct ioc_enable_lun {
	path_id_t	path_id;
	target_id_t	target_id;
	lun_id_t	lun_id;
	int		grp6_len;
	int		grp7_len;
};

The selected path (bus), target, and LUN must not already be in use or EADDRINUSE is returned. If grp6_len or grp7_len are non-zero, reception of vendor-specific commands is enabled.

TARGIOCDISABLE

Disable target mode and abort all pending CCBs. The CCBs may optionally be read as they complete. TARGIOCENABLE can then be called to activate a different LUN. Multiple disable calls have no effect. The close(2) system call automatically disables target mode if enabled.

TARGIOCDEBUG