man.bsd.lv manual page server

Manual Page Search Parameters
QLXGB(4) Device Drivers Manual QLXGB(4)

qlxgb — QLogic 10 Gigabit Ethernet & CNA Adapter Driver

To compile this driver into the kernel, place the following lines in your kernel configuration file:

device qlxgb

To load the driver as a module at boot time, place the following line in loader.conf(5):

if_qlxgb_load="YES"

The qlxgb driver supports IPv4 checksum offload, TCP and UDP checksum offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling. For further hardware information, see http://www.qlogic.com/.

The qlxgb driver supports 10 Gigabit Ethernet & CNA Adapter based on the following chipsets:

For support questions please contact your QLogic approved reseller or QLogic Technical Support at http://support.qlogic.com, or by E-mail at <support@qlogic.com>.

altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)

The qlxgb device driver first appeared in FreeBSD 10.0.

The qlxgb driver was written by David C Somayajulu at QLogic Corporation.

November 3, 2011 FreeBSD-12.0