man.bsd.lv manual page server

DESCRIPTION

The bus_alloc_resource_any() and bus_alloc_resource_anywhere() functions are convenience wrappers for bus_alloc_resource(). bus_alloc_resource_any() sets start, end, and count to the default resource (see description of start below). bus_alloc_resource_anywhere() sets start and end to the default resource and uses the provided count argument.

The arguments are as follows:

• dev is the device that requests ownership of the resource. Before allocation, the resource is owned by the parent bus.
• type is the type of resource you want to allocate. It is one of:

  PCI_RES_BUS

  for PCI bus numbers

  SYS_RES_IRQ

  for IRQs

  SYS_RES_DRQ

  for ISA DMA lines

  SYS_RES_IOPORT

  for I/O ports

  SYS_RES_MEMORY

  for I/O memory

• rid points to a bus specific handle that identifies the resource being allocated. For ISA this is an index into an array of resources that have been setup for this device by either the PnP mechanism, or via the hints mechanism. For PCCARD, this is an index into the array of resources described by the PC Card's CIS entry. For PCI, the offset into PCI config space which has the BAR to use to access the resource. The bus methods are free to change the RIDs that they are given as a parameter. You must not depend on the value you gave it earlier.
• start and end are the start/end addresses of the resource. If you specify values of 0ul for start and ~0ul for end and 1 for count, the default values for the bus are calculated.
• count is the size of the resource. For example, the size of an I/O port is usually 1 byte (but some devices override this). If you specified the default values for start and end, then the default value of the bus is used if count is smaller than the default value and count is used, if it is bigger than the default value.
• flags sets the flags for the resource. You can set one or more of these flags:

  RF_ALLOCATED

  resource has been reserved. The resource still needs to be activated with bus_activate_resource(9).

  RF_ACTIVE

  activate resource atomically.

  RF_PREFETCHABLE

  resource is prefetchable.

  RF_SHAREABLE

  resource permits contemporaneous sharing. It should always be set unless you know that the resource cannot be shared. It is the bus driver's task to filter out the flag if the bus does not support sharing. For example, pccard(4) cannot share IRQs while cardbus(4) can.

  RF_UNMAPPED

  do not establish implicit mapping when activated via bus_activate_resource(9).

	struct resource *portres, *irqres;
	int portid, irqid;

	portid = 0;
	irqid = 0;
	portres = bus_alloc_resource(dev, SYS_RES_IOPORT, &portid,
			0ul, ~0ul, 32, RF_ACTIVE);
	irqres = bus_alloc_resource_any(dev, SYS_RES_IRQ, &irqid,
			RF_ACTIVE | RF_SHAREABLE);