NAME
sensorsd —
hardware sensors monitor
SYNOPSIS
sensorsd |
[-d] [-c
check] |
DESCRIPTION
Thesensorsd utility retrieves sensor monitoring data
like fan speed, temperature and voltage via
sysctl(3). When the state of any monitored sensor changes, an alert is
sent using syslog(3) and a command, if specified, is executed.
By default, sensorsd monitors status
changes on all sensors that keep their state, thus sensors that
automatically provide status do not require any additional configuration. In
addition, for every sensor, no matter whether it automatically provides its
state or not, custom low and high limits may be set, so that a local notion
of sensor status can be computed by sensorsd,
indicating whether the sensor is within or is exceeding its limits.
Limit and command values for a particular sensor may be specified
in the
sensorsd.conf(5) configuration file. This file is reloaded
upon receiving SIGHUP.
The options are as follows:
-ccheck- Check sensors every check seconds. The shortest reporting period for state changes will be three times this value. The default is 20.
-d- Do not daemonize. If this option is specified,
sensorsdwill run in the foreground.
FILES
- /etc/sensorsd.conf
- Configuration file for
sensorsd.
SEE ALSO
HISTORY
The sensorsd program first appeared in
OpenBSD 3.5 and was imported into
DragonFly 1.11.
CAVEATS
Certain sensors may flip status from time to time. To guard
against false reports, sensorsd implements a state
dumping mechanism. However, this inevitably introduces an additional delay
in status reporting and command execution, e.g. one may notice that
sensorsd makes its initial report about the state of
monitored sensors not immediately, but about 60 seconds after it is
started.