NAME
snd_via8233 —
VIA Technologies VT8233 bridge device
driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your kernel configuration file:
device sound
device snd_via8233Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
snd_via8233_load="YES"
DESCRIPTION
Thesnd_via8233 bridge driver allows the generic audio
driver, sound(4), to attach to the VIA VT8233 audio devices. These
audio chipsets are integrated in the southbridge on many VIA based
motherboards.
Runtime Configuration
The following sysctl(8) variables are available in addition to those available to all sound(4) devices:
- dev.pcm.%d.polling
- Experimental polling mode, where the driver operates by querying the device state on each tick using callout(9). Polling is disabled by default. Do not enable it unless you are facing weird interrupt problems or if the device cannot generate interrupts at all.
HARDWARE
The snd_via8233 driver supports the
following audio chipsets:
- VIA VT8233
- VIA VT8233A
- VIA VT8233C
- VIA VT8235
- VIA VT8237
- VIA VT8251
SEE ALSO
HISTORY
The snd_via8233 device driver first
appeared in FreeBSD 4.7.
AUTHORS
This manual page was written by Joel Dahl <joel@FreeBSD.org>.
BUGS
The snd_via8233 driver does not support
S/PDIF. There is partial support in the code, so implementing it should be
fairly easy if the right hardware is available.