NAME
snd_atiixp —
ATI IXP bridge device driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your kernel configuration file:
device sound
device snd_atiixpAlternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
snd_atiixp_load="YES"
DESCRIPTION
Thesnd_atiixp bridge driver allows the generic audio
driver, sound(4), to attach to ATI IXP audio devices. This driver
supports 16bit playback and recording, and 32bit native playback and
recording.
Runtime Configuration
The following sysctl(8) variables are available in addition to those available to all sound(4) devices:
- dev.pcm.%d.polling
- Experimental polling mode, where the driver operates by querying the device state on each tick using callout(9). Polling is disabled by default. Do not enable it unless you are facing weird interrupt problems or if the device cannot generate interrupts at all.
HARDWARE
The snd_atiixp driver supports the
following audio chipsets:
- ATI IXP 200
- ATI IXP 300
- ATI IXP 400
SEE ALSO
HISTORY
The snd_atiixp device driver first
appeared in FreeBSD 6.1.
AUTHORS
This manual page was written by Joel Dahl <joel@FreeBSD.org>.
BUGS
The snd_atiixp driver does not support
S/PDIF, but implementing it should be fairly easy if the right hardware is
available.
32bit native recording is broken on some hardware.