NAME
ip6addrctl —
configure address selection policy for
IPv6 and IPv4
SYNOPSIS
ip6addrctl |
[show] |
ip6addrctl |
add prefix precedence
label |
ip6addrctl |
delete prefix |
ip6addrctl |
flush |
ip6addrctl |
install configfile |
DESCRIPTION
Theip6addrctl utility manages the policy table of
source and destination address selection for outgoing IPv4 and IPv6 packets.
When ip6addrctl is invoked without an argument or with
a single argument show, it prints the content of the
policy table currently installed in the kernel.
To modify the table, the following operations are available:
addprefix precedence label- Add a policy entry. The prefix argument is an IPv6 prefix, which is a key for the entry. An IPv4 prefix should be specified with an IPv6 prefix using an IPv4-mapped IPv6 address. The precedence and label arguments are decimal numbers, which specify the precedence and label values for the entry, respectively. This operation should be performed without an existing entry for the prefix.
deleteprefix- Delete a policy entry specified by prefix, which should be an IPv6 prefix. A corresponding entry for the prefix should have already been installed.
flush- Delete all existing policy entries in the kernel.
installconfigfile- Install policy entries from a configuration file named
configfile. The configuration file should contain a
set of policy entries. Each entry is specified in a single line which
contains an IPv6 prefix, a decimal precedence value, and a decimal label
value, separated with white space or tab characters. In the configuration
file, lines beginning with the pound-sign
(‘
#’) are comments and are ignored.
EXIT STATUS
The ip6addrctl utility exits 0 on
success, and >0 if an error occurs.
SEE ALSO
Richard Draves, Default Address Selection for IPv6, RFC 3484.
HISTORY
The ip6addrctl utility first appeared in
the KAME IPv6 protocol stack kit. The original command name was
addrselect, but it was then renamed to the current
one so that the name would describe its function well.